Teachers Notes

I used a vernier labPro interface and a vernier force sensor set at 10N range. The rope was 1.5m long and approximately 5mm diameter with a mass per unit length of 0.012 kg/m. I held the rope 1m from the sensor and spun it at 5 different rates as I measured the tension. Sampling rate : 500 Hz The Force sensor should be zeroed before commencing readings, this is done from loggerPro with Vernier sensors but on the sensor...

To access the entire contents of this site, you need to log in or subscribe to it.

Alternatively, you can request a one month free trial.